Artikla trenutačno nema. Dole se možete prijaviti i poslat ćemo vam obaveštenje kad artikal bude opet dostupan. Bićete obavešteni samo za taj artikal.
Za željeni artikal pošaljite poruku/potražnju i kontaktiraćemo vas.
Za željeni artikal pošaljite poruku/potražnju i kontaktiraćemo vas.
This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sensor.
When a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED lights up and the output pin goes high. You can also solder a wire to the middle pad and create your own capacitive pad if the built-in one isn't suited to your project.