Artikla trenutačno nema. Dole se možete prijaviti i poslat ćemo vam obaveštenje kad artikal bude opet dostupan. Bićete obavešteni samo za taj artikal.
Za željeni artikal pošaljite poruku/potražnju i kontaktiraćemo vas.
Za željeni artikal pošaljite poruku/potražnju i kontaktiraćemo vas.
Product details
UMFT230XB-WE breakout module utilizes FT230XQ IC to convert USB to basic UART module. UMFT230XB bridges from USB to UART IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.
- Single chip USB to asynchronous serial data transfer interface
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- Configurable CBUS I/O pin
- Device supplied preprogrammed with unique USB serial number
- Supports bus powered, self powered and high power bus powered USB configurations
- Integrated power on reset circuit
- Low USB bandwidth consumption
- UHCI/OHCI/EHCI host controller compatible
- USB 2.0 full speed compatible
Specifications
Silicon Manufacturer - FTDI
Silicon Core Number - FT230XB
Kit Application Type - Interface Module
Application Sub Type - USB to UART
Kit Contents - Dev Board FT230XB
Product Range -
Features - Full Speed USB2.0, 3Mbaud UART, 4 Control Bus Lines, Embedded ROM, 3.3V O/P, USB Powered, Wire Ended
SVHC - No SVHC (17-Dec-2015)